Motorola AP-6511 Guide d'installation télécharger pdf (Page 7)

Introduction

The access point contains runtime firmware which enables the unit to boot after either a power up

or a watchdog reset. The runtime firmware on the access point can be updated via the Ethernet

interface.

The front of the AP-6511 has an access cover that can be removed to expose an additional connector.

A three port RJ-45 Ethernet expansion module connects to the hidden header and snaps onto the

AP-6511 in place of the access cover.

Remove the AP-6511’s access cover by inserting a long pointed tool into the circular hole (opening)

on the bottom of the AP-6511. Pull the access cover up and away from the AP-6511. Reverse the

procedure to install the expansion module.

The Ethernet expansion module has three ports labeled FE2, FE3 and FE4.

The expansion module (KT-6511-0000D-WR) is a separately orderable component from Motorola.

1 2 3 4 5 6 7 8 9 10 11 12 ... 46 47

Pas de commentaire

Motorola AP-6511 Guide d'installation Page 7