Motorola AP 7161 Guide d'installation télécharger pdf (Page 37)

Installation Guide 37

align the top holes on the sides with the top holes on the angle adapter bracket section. Insert two M6

hex flange screws into the top holes on the angle adapter bracket section.

4. Use a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, to finish attaching the

angle adapter bracket section to the Access Point bracket section with the four M6 hex flange screws in

the open slot connections and the top holes on the angle adapter bracket section. Do not tighten the

screws until all rotation and tilt adjustments are complete.

5. To adjust the position of the Access Point, rotate the Access Point bracket section (plus or minus 15

degrees) and tilt the angle adapter bracket section (up to 45 degrees).

6. Use a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, to tighten all screws when

all adjustments are complete.

7. Tighten all hex flange screws to 60 inch pounds (lbf-in).

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 79 80

Pas de commentaire

Motorola AP 7161 Guide d'installation Page 37