Motorola F5207A, F5217A Guide de l'utilisateur Page 28

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 56
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 27
18
NOTE: Your device performance might be slightly degraded (both boot up time and
sustained operations) during extreme temperature conditions. Normal operation will
resume when the ambient temperature returns to the operating range.
Discharged Vehicle Battery
If the power source is a standard 13.8V car battery, the device will normally power
up when the voltage level exceeds 10.3 VDC.
If, during normal operation, the battery voltage drops below 10.3 VDC the device
will provide Low Battery indication - workstation power indicator blinks yellow. If
the voltage continues to drop, the device automatically powers off at 8.5 VDC.
If the power source is a 9V battery, the device will normally power up when the
voltage level exceeds 9 VDC.
Power Off
CAUTION: Never shut your workstation down by turning off the main power
switch (MAIN SWITCH) on the back panel of the CPU box while the Operating
System is working. Be aware, this operation may damage your hard disk.
CAUTION: The MW800 shut down scheme is configurable to one of three
selections: via the vehicle ignition switch, from the CPU or Display power button or
from the display power button or a combination of ignition sense and power buttons.
Be aware, the CPU and the display have the same shut down scheme.
CAUTION: Remember to save important information before turning off your
workstation.
Normal Operation
You should always shut your device down from the Windows Shut Down process.
If the MW800 is connected through the ignition and configured to be powered off
from the ignition switch, rotate the car key to OFF position. The device will
automatically shut down when the Ignition shutdown time-out expires.
NOTE: Windows pop-up dialog will warn you about power off from the ignition
switch. You can cancel this operation before the Ignition shutdown time-out
expires.
If the MW800 is not connected through the ignition but is configured to be powered
off only from the power button, momentarily press the Power button. The device will
shut down.
Vue de la page 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 55 56

Commentaires sur ces manuels

Pas de commentaire