Motorola LM2000 Guide d'installation télécharger pdf (Page 41)

2: Hardware Installation

DC 900-1331F 41

Step 8:

Make sure that the power switch on the back panel is in the off (“0”) position, then

make the LAN connections. You can obtain the necessary cables from a computer acces-

sory vendor.

Caution

Alert your system administrator before making connections to

your LAN. To avoid a disruption of service on your LAN, carefully

plan how you will make the connections. We recommend that you

power off the Freeway server and modem during cable installation

and removal.

If your Freeway has an MVME 162 CPU board, it will be possible at most sites to run

cables directly from the attachment unit interface (AUI) connectors on Freeway’s back

panel to connectors on the LAN. Other sites might require a media access unit (MAU)

adapter between Freeway and the LAN. For example, you can plug a MAU into the AUI

connector on Freeway’s back panel, then run a cable from the MAU to a connector on

the LAN. MAUs are available from Simpact or a computer accessory vendor. Check with

your system administrator to see what type of cable is used at your site. Figure 2–4 on

page 38 shows the location of an AUI connector on the back panel. When you ﬁnish

connecting the cables, lock the AUI connections by sliding the slidelock to the right as

shown in Figure 2–7.

Caution

To disconnect the cable or MAU from an AUI connector on

Freeway’s back panel, you must ﬁrst unlock the connector by slid-

ing the slidelock to the left. Failure to do so can damage your

Freeway. Figure 2–7 illustrates the slidelock.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 85 86

Pas de commentaire

Motorola LM2000 Guide d'installation Page 41