Motorola 2.1 Guide d'installation Page 29

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 952
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 28
CHAPTER 1 INTRODUCTION
This chapter describes the commands available using the controller Command Line Interface (CLI) on a Motorola Solutions
device. CLI is available for all supported devices, controllers as well as Access Points (APs).
Access the CLI by:
A terminal emulation program running on a computer connected to the serial port on the controller. The serial port is
located on the front of the controller.
A Telnet session through Secure Shell (SSH) over a network.
Configuration for connecting to a Controller using a terminal emulator
If connecting through the serial port, use the following settings to configure your terminal emulator:
When a CLI session is established, complete the following (user input is in bold):
login as: <username>
administrator’s login password: <password>
User Credentials
Use the following credentials when logging into a device for the first time:
When logging into the CLI for the first time, you are prompted to change the password.
Bits Per Second 19200
Data Bits 8
Parity None
Stop Bit 1
Flow Control None
User Name admin
Password motorola
Vue de la page 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 951 952

Commentaires sur ces manuels

Pas de commentaire