Motorola SG 2000 Instructions d'exploitation télécharger pdf (Page 36)

Installation 4

-7

AT&T SLW2500 Installation and Operation Manual

Figure 4-6

Fiber spool tray

Fiber routed to optics modules

through fiber tray pegs

4 Connect each fiber by removing the protective boot from the fiber connector, cleaning the

connector with pure isopropyl alcohol (99%) using a lint-free wipe, and drying it with filtered

compressed air. After cleaning the fiber, insert it into the appropriate receiver or transmitter

module.

5 Position the fiber service cable in the compression fitting to provide some slack in the fibers

inside the housing. Tighten the compression nut until it bottoms out. Finally, tighten the

water seal nut until there is no gap between it and the compression nut.

6 Close the housing and use a torque wrench to sequentially and progressively tighten the

housing bolts to a final torque of 12 ft-lbs. in the sequence stamped on the housing lid.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 52 53

Pas de commentaire

Motorola SG 2000 Instructions d'exploitation Page 36