Motorola MICOM-2ES Spécifications télécharger pdf (Page 38)

2-4.4 Installation of Whip Antenna

1. Visually inspect the whip mount connector (located on the ATU) for dirt

or damage. Clean if necessary.

2. Screw antenna base AB-591 into the whip mount connector. Tighten by

hand only.

3. Extend the whip: this is done by carefully whipping it outwards. Secure all

sections by inserting them one into the other by hand.

4. Screw whip antenna sections into antenna base.

5. To remove the whip antenna, perform the above tasks in the reverse

order.

CAUTION

When folding the whip, always start with the upper section,

otherwise it may be damaged.

2-12

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 55 56

Pas de commentaire

Motorola MICOM-2ES Spécifications Page 38