Motorola ASTRO W5 Guide de l'utilisateur télécharger pdf (Page 80)

Conventional Radio Features

Status Calls (Digital Modes Only)

Radio status calls are used to inform the dispatcher of the present

state of the mobile unit. For example, a status might be ENROUTE or

AT SITE.

Status names are field programmable. Each radio can have up to 8

separate statuses.

Sending a Status Call (W7 and W9 Control Heads

Only)

1 Press , and the display shows the last-acknowledged

status name.

2 Press the Mode rocker switch to review the list of status names,

or use the keypad to enter the number of the status you wish to

send.

Note: If no button is pressed for a period of time, an inactivity

warning will sound.

3 The display shows the desired status name or number, press

or the PTT button to send the transmission.

One of the following conditions occur:

• The radio display shows PLS WAIT (W7) or PLEASE WAIT

(W9) until the transmission is received and acknowledged.

When the dispatcher acknowledges the status, four high-

pitched tones sound, and the display shows ACK RCVD.

The radio then returns to normal dispatch operation.

• If the status is not acknowledged after approximately six

seconds, the display alternates between NO ACK and the

associated status name. A low-pitched tone also sounds

continuously.

Sts

Sel

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 157 158

Pas de commentaire

Motorola ASTRO W5 Guide de l'utilisateur Page 80