Motorola WE800G Manuel d'utilisateur télécharger pdf (Page 18)

SECTION 2, INSTALLATION 2-1

Section 2:Installation

To get your network up and running:

1 Setup your hardware.

CAUTION!

Use only the Motorola supplied WE800G power adapter.

2 Insert the CD-ROM for Software Setup. Follow the prompts.

If you prefer to setup the Wireless Ethernet Bridge software

manually, refer to the Manual Software Setup found in this section.

The following sections provide detailed instructions for completing

these tasks.

Hardware Setup

Hardware setup includes:

! Antenna Installation: connecting the antenna to the unit.

! Physical Installation: where you physically place your unit.

! Electrical Connection: how to power your unit.

Antenna Installation

When shipped, the antenna is already installed on the main unit. If,

for some reason, you have to detach and than re-attach the antenna

to the main unit:

1 Take the bottom of the antenna and locate, on the right backside

of the Wireless Ethernet Bridge, the threaded knob.

2 Screw the antenna connector (counter-clockwise to remove,

clockwise to attach) on to the threaded knob until firmly seated.

When attaching, do not over-tighten.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 70 71

Pas de commentaire

Motorola WE800G Manuel d'utilisateur Page 18