Motorola HT-1000 - SERVICE Manuel de service télécharger pdf (Page 143)

Appendix A- 5

enable the secure options by updating the codeplug, and how to tune

the radio for optimum secure performance.

Physical Retrofit of

Secure Module

The radio must be partially disassembled to install the secure module.

Follow the disassembly procedures in Section 6, located toward the

front of this manual. Proceed through “Disassembly to Board Level”)

step 8, where the front cover has been removed and the controls flex

has been disconnected from the controller board.

Continue through step 9a, to loosen the front shield. Do not

completely remove the front shield. Simply raise the lower portion of

the shield while the opposite end is still connected to the top of the

radio. With the front shield raised, observe the controller board which

takes up the bottom third of the radio. On the lower right corner of the

controller board is an empty female connector, which will be used to

mate the controller board to the secure module. Place the secure

module (component side toward controller board) over the controller

board with the secure module’s male connector placed above and

aligned to the female connector on the controller board. Interlock the

connectors by pressing down on the back of the secure module. The

secure module has now been installed. Reassemble the radio according

to the reassembly instructions in Section 6, located toward the front of

this manual. Begin with “Reassembly (Control Top/Front Shield/

Controls Flex as a unit to Chassis), step 2.

Update Codeplug Through

RSS

General Once the secure module is installed, the radio's codeplug must be

reprogrammed so that the new hardware can be used. There will also

be some secure options that the user may or may not want to activate.

Appendix Table 3, at the end of this appendix, gives a quick reference

to several properties and a brief description for each parameter. Refer

to the RSS manual for general instructions in the use of RSS.

Set Secure-Equipped Field The radio must be reprogrammed to utilize the secure module. At the

RSS main menu, press F4 for the CHANGE/CREATE/VIEW menu. Press

F3 for the Radio Wide Buttons, Switches, Display, Scan, Phone screen.

Press F2 for Radio Wide Options screen. Here, press tab to reach the

Secure Equipped field. Press up/down arrow keys to select YES.

Set XL IC Present Field If the secure module has an XL IC (the Range Extension or -XL option),

the radio must be reprogrammed to show that this IC is present. While

still in the Radio Wide Options screen, press F6 to see Secure Options.

Press Tab until the XL IC Present field is highlighted. Press up/down

arrow keys to select YES. If the secure module does not have an XL IC,

set the XL IC Present field to NO.

C a u t i o n

Anti-static precautions must be observed at all

times.

1 2 ... 138 139 140 141 142 143 144 145 146 147 148 ... 169 170

Commentaires sur ces manuels

Pas de commentaire

Motorola HT-1000 - SERVICE Manuel de service Page 143

Commentaires sur ces manuels

Produits connexes et manuels pour Radios Motorola HT-1000 - SERVICE