Motorola MTM5400 Manuel d'installation Page 27

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 80
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 26
INSTALLATION MTM5400 Mobile Terminal Installation Manual 27
INSTALLATION
Introduction
General Information
There are two methods of installing the mobile terminal in a vehicle:
1. Using the direct mounting trunnion and power cables supplied with a standard radio package.
2. Remote mounted in the car radio cut-out (using the required DIN mounting kit PMLN5094),
per ISO7736.
An accessory connector on the rear of the terminal enables you to attach different accessories (see
section
“Accessory Connection Plan”).
A mobile microphone port on the front control head panel (see page 65) provides for the connection
of various types of microphones (Desktop Microphone RMN5106 or Compact Microphone
RMN5107).
1. Mount the terminal horizontally near the driver, so the driver can easily view, access and
operate the controls and accessories.
2. Ensure that the location is not exposed to dirt and moisture.
3. Verify that there will be sufficient space around the mobile unit for air flow and installation.
4. Check that there is enough routing space for the power cable connector and the antenna
coaxial cable.
5. Plan the best place to run connections to minimize pinching, crushing, and overheating of
wires and cables.
This product must be installed in a vehicle in accordance
with the vehicle manufacturer’s guidelines and the
instruction detailed in this manual.
Only the specified Motorola parts in this manual should be
used. Failure to do so could result in non compliance to
the Automotive Directive (72/245/EEC, as amended by
95/54/EC).
For products fitted to two and three wheeled vehicles,
Directive 97/24/EC applies.
This Terminal is only designed and certified to be used for
terrestrial use only.
This terminal is ONLY made for 12 V power supply
connection. In vehicles with 24 V power supply, a DC/DC
converter is required.
Please be aware when planning the installation that there
is a current consumption of approx. 4.5 A during PTT and
up to 30 mA when terminal is switched off.
Vue de la page 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 79 80

Commentaires sur ces manuels

Pas de commentaire