Motorola Command One Manuel d'utilisateur télécharger pdf (Page 20)

2-4 Universal Command Converter Motorola

Host Computer Interface Card

Secure the host interface card to the PC-workstation chassis using the bracket retaining

screw. Refer to the PC-workstation installation and set-up manual for instructions on

reinstalling the cover.

The host interface card is factory-configured for no interrupts and address decoding at

$100–$102 of the PC-workstation I/O address map, which are undefined peripheral

addresses.

Note: Jumper JG2 should be left disconnected.

2.1.2 Installing the PC-Workstation Software

A GUI debugger program that supports multiple windows, menus, and dialog boxes is

available for use in the Microsoft Windows environment.

2.1.2.1 Defining Environment Variables

The following sections specify environment variables which may need to be defined to

establish the correct operating environment for the ADS user interface software. These

environment variables may be defined during system start-up by adding lines to the file

c:\autoexec.bat, which applies to all versions of DOS and WINDOWS operating systems.

Some Windows 95 installations may not use the autoexec.bat file. If it does not exist, it

may be created and the SET commands inserted.

The general form of the SET command is as follows:

SET symbolname=value

Use the names and values from the sections below, and do not use spaces around the “=”

sign.

If the I/O address of the host interface card is changed from the default setting of $100, the

ADS user interface program must be informed of the address to access the card. This may

be done with the environment variable ADMADDR:

set admaddr=200

2.1.2.2 GUI Program Installation

To install the development software, place the Motorola DSP Software Development

Tools CD in the CD drive. If the Motorola DSP Software Development Tools Setup does

not appear within fifteen (15) seconds of activating the CD drive, you will have to

manually install the software. To do so, position the mouse pointer over the Start icon on

the Windows 95/NT toolbar and click once to bring up the selections. Move the mouse

pointer to Run and click once. Move the mouse pointer to Browse and click once. In the

dialog window that appears, select the CD drive on the computer. The file SETUP.EXE

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 69 70

Pas de commentaire

Motorola Command One Manuel d'utilisateur Page 20