Motorola HS805 - Headset - Over-the-ear Manuel de service télécharger pdf (Page 40)

BASIC LEVEL CHECKS AND SELF TESTS: Mechanical and Electrical Checks

68P80401P01-O 5-3

4. Wipe and dry the unit with a soft, absorbent, lint-free cloth. Make sure that there are no damp

spots on the connectors or in cracks and crevices.

5.5 Mechanical and Electrical Checks

Before conducting more complex tests, clean and check the unit for any mechanical defects that

might cause or contribute to the problem.

The following tests constitute the mechanical and electrical consistency of the unit:

• Shock and Pressure

• SIM Card Swap

• Accessory Swap

• Lockup

• Battery Connections

• GPS Receiver

• Voltage Recognition

• Camera Test

• Bluetooth Hands Free

Shock and Pressure Test

Use this test to determine if controlled shock and pressure can repeat a reset or intermittent contact

condition.

NOTE: Perform this test with the rear housing securely in place and antenna completely pushed

in.

The Shock and Pressure test time is approximately 3 minutes:

1. Power up the unit.

2. Throw the unit into the palm of your hand alternating the front, sides, and back of the unit.

Check if the unit turns off, displays “Reset,” or status LED (if so equipped) turns to red. Then,

continue to the next step.

3. Apply pressure to the front, sides, and back of the unit with your thumbs. Never apply direct

pressure to any display or lens area.

If unit turns off, displays “Reset,” or status LED (if so equipped) turns to red, retry this test with

a battery known to be in good working condition. Verify that the contacts in the unit and on the

battery are clean.

4. Start test again. If the reset/intermittent contact condition persists, power down the unit and

send to your iDEN Customer Support Center.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 111 112

Pas de commentaire

Motorola HS805 - Headset - Over-the-ear Manuel de service Page 40