Motorola LD-W-1 Spécifications télécharger pdf (Page 26)

English LD-G-1 / LD-W-1

Page 54

Operation

Acceleration and brake delay / Second velocity characteristic

In Motorola II format you can switch the acceleration and brake delay

on or off and you can switch between the two velocity characteristics

via F4.

F4 off: Delay active and characteristic 1 set.

The setting is immediately active.

In Motorola I format you cannot switch the acceleration and brake

delay on or off and you cannot switch to the second velocity

characteristic. The acceleration and brake delay is always active.

An emergency stop can be made via the central unit by reversing the

direction.

Improvement of the driving characteristics

Locomotives with especially high current consumption or track sections

with bad contacts (e.g. some types of points) may give an

unsatisfactory performance. You can improve the locomotive

performance by soldering a capacitor 100 µF / 35 V between X16 and

X17 (see fig. 2a resp. 2b).

Analogue mode

In analogue mode the decoder can be run like a change-over switch. This

means the decoder reacts with a change of direction on the shift impulse

of the speed control knob, as usual. In analogue mode the lighting and

the accessory connected to X6 are always switched on.

The lighting is switched depending on the direction of travel.

You access the analogue mode by pressing the direction switch of the

analogue driving transformer until the light of the locomotive starts flashing.

To get back into the digital mode, press the direction switch of the analogue

driving transformer again until the light of the locomotive starts to flash.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 35 36

Pas de commentaire

Motorola LD-W-1 Spécifications Page 26