Motorola Phaser P460 Instructions d'exploitation télécharger pdf (Page 24)

2-5

Set Up

whereas a scanner with a partially charged battery begins charging after approximately 15

minutes. Note that the scanner can be removed from the cradle at any time.

Using the Cable

1. Connect the cable to the scanner.

2. Connect the power supply to the power jack on the cable.

3. Connect the power supply to a receptacle supplying AC power of the proper

voltage level.

4. The battery charges automatically. A full charge of a depleted battery takes

approximately 3-1/2 hours.

Battery Charge

When the battery’s charge is almost depleted, the scanner emits 4 high tone beeps, when

the trigger is pulled, indicating that it must be recharged.

Connecting to a Host

With some host types, the Phaser is unable to answer host terminal polls if the appropriate

host type is not selected. This may result in an error message generated by the host. To

correct this situation, select the proper parameter set and initialize the host terminal. See

Chapter 5, Parameter Menus for more information.

There are two basic host communications options available.

When using as a batch device running on a battery, you can transmit stored data

to a host either through an RS-232 or a Synapse cable connected directly to the

scanner, or through the cradle, as described in Setting Up the Cradle on page 23.

When using as a corded device, power and host communications takes place via

RS-232 or Synapse cables.

RS-232 Power Supply Operation

1. Make sure all host devices are powered down.

2. Plug the connector at the end of the scanner’s or cradle’s cable into an appropriate

RS-232 receiving port on the host device.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 207 208

Pas de commentaire

Motorola Phaser P460 Instructions d'exploitation Page 24