Motorola Phaser P460 Instructions d'exploitation télécharger pdf (Page 60)

5-1

Chapter 5

Parameter Menus

Introduction

This chapter has the optional parameter bar codes necessary to program the Phaser

scanner.

Operational Parameters

The Phaser is shipped with the settings shown in Table 5-1. These default values are stored

in non-volatile memory and are preserved even when the scanner is powered down. You

can change these default values by scanning the appropriate bar codes included in this

manual. These new values replace the standard default values in memory. The default

parameter values can be recalled by scanning the bar code in the section Set Default

Parameter on page 5-9.

The scanner automatically detects which cable it is attached to, either an RS-232 or a

Synapse cable. If it is attached to an RS-232 cable and has either an ICL, Nixdorf, or Fujitsu

host interface, then scan the appropriate bar code from page 5-13 after power up. Any other

host interface works with the default setting.

If it is attached to a Synapse cable, plug everything together as described on page 2-6 and

then follow the directions that come with the Synapse cable for setting up the host interface.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 207 208

Pas de commentaire

Motorola Phaser P460 Instructions d'exploitation Page 60