Motorola LD-W-1 Spécifications télécharger pdf (Page 11)

English LD-G-3 / LD-W-3

Page 30

Performing a visual check

Damaged materials can cause injury. Parts damaged during transit can

also be dangerous.Check the module for damage, missing parts or poor

soldering. If you find damage, return the module for exchange.

Mounting the locomotive decoder

Open the locomotive housing. Locate the position for the decoder.

Disconnect the motor from the rail current collector respectively the

change-over switch from the motor and rails if you have a locomotive

with electronic change-over switch. The change-over switch is no

longer necessary, you can remove it.

Caution:

The interference suppression devices mounted to the motor or the

connecting wire must not be removed! Motor and interference

suppression devices are one unit. If even one part is removed, it can

cause extreme interference!

Connecting the LD-G-3

Follow the connections diagrams (fig. 1)! Solder the connection to the

slider at point X2, and the connection to the housing to point X3. These

two connections can be exchanged without effecting functionality.

Solder the connections to the motor at the points X10 and X11.

Connecting the LD-W-3

Follow the connections diagrams (fig. 2)! Solder the connection to the

slider at point X2 and the connection to the housing to point X3. These

two connections can be exchanged without effecting functionality.

Solder the connections to the motor at the points X6, X10 and X11.

Connecting the lighting

Follow the connections diagrams (fig. 1, 2 and 3)!

Disconnect any existing diodes in the leads to the lamps. Connect the

lamps for forward motion to X5 and the lamps for reverse to point X4.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Pas de commentaire

Motorola LD-W-1 Spécifications Page 11