Motorola MICOM-2TS Spécifications télécharger pdf (Page 113)

MICOM-2E-ALE Owner’s Manual

Step 1.

Bring the power connector on the DC Power Cable to the radio

DC connector but do not attach it to the radio. Then bring the

three heavy wires (RED, GRN, BLK) to a 12-V battery, passing

them through access holes as required.

NOTE

The wires must be as short as possible. They should

be cut down to a minimum as required.

Step 2.

Thread the ends of the red and green wires from the power

connector through the two fuse holder caps. Cut apart the two

fuse clips and solder or crimp them to the wires.

Step 3.

Install the 30-A fuse in the fuse holder on the red wire, and the

7.5 A fuse in the fuse holder on the green wire. Then assemble

the fuse holders.

Step 4.

Crimp or solder the supplied lugs to the red, green, and black

wires.

Step 5.

Connect the lugs on the red and green cables together to the

positive terminal of the battery. Then connect the lug on the

black wire to the negative terminal of the battery.

NOTE

1. It is recommended to attach the black (ground)

wire to the vehicle’s chassis. The point of

attachment should be located as close as

possible to the radio. Refer to Figure 9.

2. In front installation, add one ferrite (supplied with

the installation radio kit) on the DC cable as

close as possible to the radio.

3. In trunk mount installation, add one ferrite

(supplied with the installation radio kit) on the

DC cable as close as possible to the radio and

one farrite on the control cable between the

control head and the radio.

1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 131 132

Pas de commentaire

Motorola MICOM-2TS Spécifications Page 113