Motorola MPC564EVB Manuel d'utilisateur Page 95

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 98
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 94
MPC564EVB Users Manual B-1
Appendix B
Configuring dBUG for Network
Downloads
The dBUG module has the ability to perform downloads over an Ethernet network using the Trivial
File Transfer Protocol, TFTP (NOTE: this requires a TFTP server to be running on the host
attached to the board). Prior to using this feature, several parameters are required for network
downloads to occur. The information that is required and the steps for configuring dBUG are
described below.
B.1 Required Network Parameters
For performing network downloads, dBUG needs 6 parameters; 4 are network-related, and 2 are
download-related. The parameters are listed below, with the dBUG designation following in
parenthesis.
All computers connected to an Ethernet network running the IP protocol need 3 network-specific
parameters. These parameters are:
Internet Protocol, IP, address for the computer (client IP),
IP address of the Gateway for non-local traffic (gateway IP), and
Network netmask for flagging traffic as local or non-local (netmask).
In addition, the dBUG network download command requires the following three parameters:
IP address of the TFTP server (server IP),
Name of the file to download (filename),
Type of the file to download (filetype of S-record, COFF, ELF, or Image).
Your local system administrator can assign a unique IP address for the board, and also provide you
the IP addresses of the gateway, netmask, and TFTP server. Fill out the lines below with this
information.
Client IP:___.___.___.___(IP address of the board)
Server IP:___.___.___.___(IP address of the TFTP server)
Gateway:___.___.___.___(IP address of the gateway)
Netmask:___.___.___.___(Network netmask)
B.2 Configuring dBUG Network Parameters
Once the network parameters have been obtained, the dBUG Rom Monitor must be configured.
The following commands are used to configure the network parameters.
set client <client IP>
set server <server IP>
Frees
cale Semiconductor,
I
Freescale Semiconductor, Inc.
For More Information On This Product,
Go to: www.freescale.com
nc...
Vue de la page 94
1 2 ... 90 91 92 93 94 95 96 97 98

Commentaires sur ces manuels

Pas de commentaire