Motorola CPCI-6115 Manuel de service télécharger pdf (Page 103)

Chapter 8 Drive Removal and Installation

CPX8216 and CPX8216T Installation and Use (6806800A52C)

4. Remove the two retaining screws from the top and bottom of the drive carrier.

5. Pull the drive carrier straight out of the peripheral bay.

At this point you can:

■ Replace the drive module with another driver module

■ Remove the drive from the drive carrier and replace it with another drive (see Removing the

Drive from the Standard Carrier and Installing the Drive In the Standard Carrier

■ Replace the drive module with an empty carrier (needed for EMI shielding)

Removing the Drive from the Standard Carrier

These steps should be performed with the drive module resting on a flat, static-free surface with

the component side down to prevent damage to the drive.

Refer to the next figure while following these instructions.

1. Remove the screws from the guide rails. Remove the guide rails from the sides of the carrier.

2. Remove the four screws fastening the drive to the carrier.

If you are not going to fill the empty drive bay with another drive, reinstall the guide rails and

replace the empty drive carrier back in the slot.

2420 9811

2414 9811

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 173 174

Pas de commentaire

Motorola CPCI-6115 Manuel de service Page 103