Motorola MVME2400 Series Manuel de service Page 204
- Page / 354
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
3-18 Computer Group Literature Center Web Site
System Memory Controller (SMC)
3
ROM/Flash Interface
The SMC provides the interface for two blocks of ROM/Flash. Each block
provides addressing and control for up to 64Mbytes. Note that no ECC
error checking is provided for the ROM/Flash.
The ROM/Flash interface allows each block to be individually configured
by jumpers and/or by software as follows:
1. Access for each block is controlled by three software programmable
control register bits: an overall enable, a write enable, and a reset
vector enable. The overall enable controls normal read accesses.
The write enable is used to program Flash devices. The reset vector
enable controls whether the block is also enabled at $FFF00000 -
$FFFFFFFF. The overall enable and write enable bits are always
cleared at reset. The reset vector enable bit is cleared or set at reset
depending on external jumper configuration. This allows the board
designer to use external jumpers to enable/disable Block A/B
ROM/Flash as the source of reset vectors.
2. The base address for each block is software programmable. At reset,
Block A’s base address is $FF000000 and Block B’s base address is
$FF400000.
As noted above, in addition to appearing at the programmed base
address, the first 1Mbyte of Block A/B also appears at $FFF00000-
$FFFFFFFF if the reset vector enable bit is set.
3. The assumed size for each block is software programmable. It is
initialized to its smallest setting at reset.
4. The access time for each block is software programmable.
5. The assumed width for Block A/B is determined by an external
jumper at reset time. It also is available as a status bit and cannot be
changed by software.
When the width status bit is cleared, the block’s ROM /Flash is
considered to be 16 bits wide, where each half of the SMC interfaces
to 8 bits. In this mode, the following rules are enforced:
a. only single-byte writes are allowed (all other sizes are ignored),
and
- MVME2400-Series 1
- VME Processor Module 1
- Programmer’s 1
- Reference Guide 1
- Restricted Rights Legend 2
- ©Copyright Motorola 1999 4
- All Rights Reserved 4
- March 1999 4
- Safety Summary 5
- Safety Depends On You 5
- Contents 7
- Glossary 14
- List of Figures 15
- List of Tables 17
- 1Board Description and 21
- Memory Maps 21
- Overview 23
- Feature Summary 23
- System Block Diagram 24
- 2067 9708 26
- Configuration 36
- PCI MEMORYPROCESSOR 42
- PCI Memory 44
- Processor 44
- ISA Space 44
- PCI I/O Space 44
- ISA Local Resource Bus 49
- VME Registers 51
- Introduction 59
- ❏ Interrupt Controller 60
- Block Diagram 61
- PPC Bus Interface 63
- ❏ HAWK (Highest Priority) 74
- ❏ CPUy (Lowest Priority) 74
- PCI Bus Interface 76
- ❏ Memory and I/O 87
- ❏ Configuration 87
- ❏ Special Cycle 87
- ❏ Interrupt Acknowledge 87
- PPC Address + Offset 88
- PCI Address 88
- 0 0 0 0 0 0 0 88
- Endian Conversion 95
- 1916 9610 96
- Error Handling 98
- Watchdog Timers 99
- PCI/PPC Contention Handling 102
- Functional Description 103
- Transaction Ordering 104
- PHB Hardware Configuration 106
- External Interrupt Interface 108
- Architecture 108
- CSR’s Readability 109
- Interrupt Source Priority 109
- Nesting of Interrupt Events 110
- Spurious Vector Generation 110
- 8259 Compatibility 111
- PHB Detected Errors 111
- Interrupt Delivery Modes 112
- Block Diagram Description 113
- Programming Notes 118
- Operation 120
- Architectural Notes 121
- Registers 123
- MBT Time Out Length 128
- 00 256 µsec 128
- 01 64 µsec 128
- 10 8 µsec 128
- 11 disabled 128
- PCI Registers 153
- $CFB $CFA $CF9 $CF8 162
- $CF8 $CF9 $CFA $CFB 162
- MPIC Registers 166
- Timer 0 - $01100 176
- Timer 0 - $01120 178
- Processor 0 $20080 184
- 3System Memory Controller 187
- Block Diagrams 188
- PowerPC 60x Bus 189
- SDRAMPowerPC 190
- Side Side 190
- PowerPC 60x Bus Interface 199
- ROM/Flash Interface 204
- I2C Interface 209
- Refresh/Scrub 221
- CSR Accesses 221
- External Register Set 221
- Chip Configuration 221
- Programming Model 222
- Table 3-9. Register Summary 223
- ERR_SYNDROME 236
- SBE_COUNT 236
- ERROR_ADDRESS 238
- I2_DATARD 252
- Software Considerations 262
- Possible Control Bit Values 266
- ECC Codes 274
- 4Universe II (VMEbus to PCI) 277
- Registers (UCSR) 283
- Universe II Register Map 284
- Register Name 285
- LSI0_TO 285
- LSI1_TO 286
- LSI2_TO 286
- LSI3_TO 286
- VSI0_TO 288
- VSI1_TO 288
- VSI2_TO 288
- VSI3_TO 288
- VCSR_TO 289
- 5Programming Details 291
- Interrupt Handling 292
- Hawk MPIC 293
- 8259 Interrupts 294
- ISA DMA Channels 297
- Exceptions 298
- Soft Reset 299
- Endian Issues 301
- Figure 5-3. Big-Endian Mode 302
- PCI Local Bus 302
- 60X System Bus 302
- Processor/Memory Domain 304
- MPIC’s Involvement 304
- PCI Domain 304
- Universe II’s Involvement 305
- VMEbus Domain 305
- ROM/Flash Initialization 306
- Ordering Related 307
- Documentation 307
- Manufacturers’ Documents 308
- Publication 309
- Document Title and Source 309
- Related Specifications 311
- MVME2400 VPD Reference 315
- Information 315
- Field Size 319
- VPD data packet 320
- Example VPD SROM 322
- Numerics 341
- 2-87, 2-89 348
- Programmer’s Reference Guide 353
Produits connexes et manuels pour Processeurs Motorola MVME2400 Series
Processeurs Motorola CPU32 Manuel d'utilisateur
(646 pages)
(646 pages)
Processeurs Motorola DSP56800 Spécifications
(28 pages)
(28 pages)
© 2020, manymanuals.fr. Tous droits réservés | 6.363 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels